Unitree GO-M8010-6
The Go1 joint motor sold separately — the single cheapest way to buy a properly engineered legged-robot actuator with real torque density.
The role it plays
An actuator turns electrical power into motion. The useful unit is never the motor alone — it is motor + reduction + encoder + driver loop, and most of the engineering is in the last three. The number that decides a design is continuous torque at the joint, not the peak figure on the datasheet. Peaks last milliseconds; gravity lasts all day.
Typical use: Quadruped hips and knees, custom legged platforms.
What the numbers actually mean
The headline figure is 23.7 N·m (peak torque), with ~6 N·m as the next most load-bearing number (rated torque). At $200 in the actuators tier it sits in the mid range: enough money that you should plan the mounting and wiring before ordering, but not so much that one mistake ends the project.
How it compares
Same subsystem, closest alternatives. The primary spec column is usually the one that decides it.
| Part | Price | Primary spec | Second spec |
|---|---|---|---|
| Unitree GO-M8010-6QDD joint motor | $200 | 23.7 N·m | ~6 N·m |
| Feetech STS3215Serial-bus servo | $17 | 30 kg·cm (2.94 N·m) @ 7.4 V | ~0.222 s / 60° |
| Feetech SCS0009Micro serial servo | $8 | 9 kg·cm (0.88 N·m) @ 6 V | ~0.1 s / 60° |
| Dynamixel XL430-W250-TSmart servo | $50 | 1.5 N·m @ 12 V | 59 rpm @ 12 V |
| Dynamixel XM430-W350-TSmart servo | $260 | 4.1 N·m @ 12 V | 46 rpm @ 12 V |
Where it shows up
Platforms in this atlas that use something in this class: MIT Mini Cheetah.